AK Gen 1 relays.

[Wheelnutter]

Many thanks Mike. Looks like I will get it sorted. Thanks again.

[Mike Hamblin]

Here is a bit more information that might help you if you do not have an AK build manual

[Wheelnutter]

Thanks all for the replies. My relay board looks older than the ones shown in the photos. Thanks for making the effort of the photos  and showing me yours.   Mine is marked one to six from right to left. I know that number one is for the indicators 12vx4. Didn't remove that one as it was stuck. Numbers 4,5,6 are 30amp relays. Had those marked ok. Not sure what was in numbers 2,3 spaces. Not sure if I lost them when testing them. Old age is a terrible thing.  Such a waste seeing on old guy in his 80s driving a Cobra.  Many thanks again. Hugh

[Mike Hamblin]

Made the photos smaller, here you go I hope this helps

[Mike Hamblin]

I have some photos of the AK relays, that might help you.
1 set is for the wipers and idicators etc, the other is the fuel pump etc.
Plus a bit of write up, photos are to big to post on here.
Send me your email address and I will send you the info

[Wheelnutter]

Hi all, Had an electrical problem which turned out to not be a problem at all but a bad earth. I removed the  relays to check them but made a mistake not taking a photo before removal.  Problem now is i'm not sure if all the relays were put back in. Now have a couple of blank spaces.  Does any one have a list of the relays or a photo of them in situi. As I built the car in 2006 a Gen 1 cobra, no one sems to have the info re the relays. Any information would be appreciated. Many thanks.  Hugh